GULFSPIC :: Welcomes You

GulfSpic

Director Engineering

Process Engineering
Services:

Mechanical Engineering
Services:

Stationary Equipment
Pre - Bid Engineering and Estimation
Preparation of technical bid for Projects
Preparation of Mechanical Data sheets
Preparation of Engineering Specifications and Engineering Standards
Design and Specification for Pressure vessels, Heat exchangers, Columns, Storage Tanks, Flare stacks, Fired heaters, Air Coolers etc.
Preparation of necessary Engineering Documents for getting statutory clearances
As Built Documentation
Stationary Equipment

Vessel & Equipment
Services:

Piping Design
Services:

Storage Tank
Services:

Civil & Structural Engineering
Services:

Cost Estimation for Techno Economic Feasibility Report (TEFR) and Detailed Project Report
Surveying
Foundation Engineering and FEM analysis
Analysis and Design of Plant, Utilities, Off sites, Buildings and Structures
Detailing and preparation of shop fabrication drawings for structures
Tender preparation, enquiry, negotiation and order placement
Construction review meeting and problem solving
Debottlenecking studies
Roads, Embankments, Trenches, Drains - Design
Infrastructural facilities
Selection and Co-ordination for architectural design
As Built documentation

Electrical Engineering
Services:

Detailed Design and Engineering
Engineering specifications for Transformers, EHV equipment, HV, MV & LV switch gear, Cables etc.
Techno economic study of system voltage and high voltage equipment
Preparation of Single Line Diagram, Lighting, Power and Earthing Layout, Cable Schedules etc.
Schematics for Interlocks and Controls
Area Classification drawings
Procurement of total electrical system including Telephone, Paging, Fire alarm, Uninterrupted Power supply system, Power Factor improvement, Emergency DG and Captive power plant.
Fault level calculations
Voltage drop, lighting, earthing, lightning protection calculations
As Built Documentation

Instrumentation Engineering
Services:

Review of Piping and Instrumentation Diagrams
Preparation of Instrument Schedules
Instrument Data sheet, Bid Specifications
Specification for Distributed Control System
Programmable Logic Controllers
Preparation of Bill of Materials and Erection Tenders
Inspection services
Preparation of Process safety/interlock system drawings
Specifications for control panel
Loop & Hook up drawings
Sizing of Control valves, Flow elements and Safety valves
Preparation of Instrument layout drawings, cable routing drawing and cable schedules
Specifications of electronic instrumentation and Distributed Digital Control System.

Licensed Software
The licensed software that are using in our Engineering Department is listed below::

GulfSpic

Engineering Facility